![]() ![]() The chairs have perfectly good metal frames and just need new webbing, making them perfect macrame lawn chair candidates!Īs I searched for macrame pattern inspiration, I noticed there's a major lack of detailed instructions. I love macrame, and a macrame lawn chair is one of those DIY projects that I have always wanted to try! In the spirit of getting my place cleaned up and organized, I decided to upcycle some of my lawn chairs that have seen one too many summers. I've been noticing a lot more macrame furniture out there lately. Now sit back and relax in your brand new lawn chair.Want to make a personalized macrame lawn chair? Decide on the color and add a personal touch to your very own lawn chair by revamping an old one with this DIY macrame lawn chair guide! Make A Macrame Lawn Chair For A Comfy Lounge – This post was originally by and shared with permission – Trim the cord & carefully burn the end to seal.ġ7) Begin the horizontal cords in the same way you started the vertical ones.ġ8) For this weave, we did the vertical rows 4 strands thick and the horizontal rows 6 strands thick. Feel free to experiment with different variations here. 15) Pull the cord up through the last loop.ġ6) Tie another double snake knot or secure knot of your choice. 12) Wrap the final strand over and behind the top bar.ġ3) Take the end of the cord and pull it down through the last loop.ġ4) Pull the strand under and around the bottom bar. Trim the inner strands that are sticking out and carefully burn the end with a lighter to seal. ![]() Tip Demonstrated Above: After each new loop is woven, an easy way to tighten the rope is to pull the placeholder straight out from the chair, and then pull on the lead rope that is still attached to the spool.Īvoid going too close to the corners of the chair.ġ1) Once you're all the way across, measure the last strand about a foot past the bottom bar and cut. Tip Demonstrated Above: If you're using something like I am for the placeholder, it's helpful to use the new loop to push the end of the pencil through the second loop so that you don't drop the stitch. You'll end up with a chair that won't open. Make sure you are pulling the cord taught, but don't yank it as tight as you can. 10) Pull cord tight.Ĭontinue this process along the whole bar. 8) Pull it towards the outside of the chair and through the previous loop that your placeholder is in.ĩ) Carefully remove the placeholder and put it through the new loop. 6) Pull another loop up and over the top bar.ħ) Tuck it under the back of the chair like the first loop. Next, wrap it under the fold bar and use your second pencil or placeholder to replicate that process on the bottom bar. If you're serious about your weaving or you're going to do a lot of these, you might want to invest in a couple of crochet needles like these. 4) Tuck it behind and towards the outer edge of the chair.ĥ) Grab your pencil or similarly shaped place holder and slide it into the loop, then pull the cord tight. 2) Pull some slack out of the spool and wrap it around the back (underneath the fold bar), then up towards the top of the chair.ģ) Pull a loop over the front of the top bar. This is where it will stay throughout the entire weaving process.ġ) Start with a secure knot, a double square knot will do just fine. Place your spool on the ground inside the seat frame. ![]() ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |